Jan 18, 2024 Leave a message

Why Can A Small Amount Of Silicon Carbide Be Used In Smelting Ferrosilicon?

Adding a small amount of silicon carbide (SiC) when smelting ferrosilicon can save some electrical energy. The "silicon carbide" referred to here is not a specific raw material, but the thermal insulation waste of the graphitization furnace when manufacturing graphite electrodes. It contains a large amount of silicon carbide, so it is customary to call this waste "silicon carbide".

 

Its ingredients are as follows:

SiC25~40%; SiO220%; C25%; the rest is Al2O3 and CaO, etc. Why adding a small amount of "silicon carbide" during smelting can reduce power consumption.

Ferro silicon 75 manufacturers

When smelting ferrosilicon, the reduction of silicon dioxide is a reaction that absorbs a large amount of heat energy. Therefore, the reaction must be carried out intensely at a very high temperature (approximately 1800 to 1900°C), thus consuming a large amount of electrical energy. When part of silicon carbide is added to the charge, it reacts with the steel scraps in the charge as follows in the furnace:

SiC+Fe= FeSi+C

 

This reaction is an endothermic reaction, and the heat absorbed and the reaction temperature are lower than those required for the reduction of silicon dioxide. Therefore, adding part of silicon carbide to the furnace charge can reduce power consumption.

Ferro silicon 75 suppliers

In smelting 45 ferrosilicon, due to the large amount of steel scraps in the charge, the destruction reaction of silicon carbide is mainly carried out according to SiC+Fe= FeSi+C. Therefore, the utilization rate of silicon carbide is higher at this time.

 

When smelting 75 ferrosilicon, there are less steel scraps and more silica in the charge. The destruction reaction of silicon carbide will mainly proceed as follows:

2SiO2+SiC= 3SiO+CO↑

SiO+SiC=2Si+CO↑

Both reactions are carried out at high temperatures above about 1800°C, and gaseous SiO participates in the reaction. Since gaseous SiO is more volatile, the reaction that destroys silicon carbide cannot be carried out safely. It can be seen that when smelting 75 ferrosilicon, the utilization rate of silicon carbide is low.

Ferro silicon 75 factory

Practice has proved that when smelting 45 ferrosilicon in a large-capacity submerged arc furnace, adding part of silicon carbide has a more significant effect. When smelting 75 ferrosilicon, some silicon carbide is added, but the effect is not significant.


Silicon carbide has a high melting point and strong electrical conductivity. After adding reinforced silicon during smelting, the electrode is not easy to stabilize and the furnace conditions are difficult to control. Moreover, there is a lot of silicon carbide powder, which affects the air permeability of the material surface and sometimes causes serious ignition. For this reason, it is not easy to add too much silicon carbide during smelting, and the silicon carbide used should be carefully selected to reduce powder.


Experience has proven that when smelting 45 ferrosilicon, 50 to 70 kilograms of silicon carbide can be added to each batch of material (silica is calculated as 300 kilograms); when smelting 75 ferrosilicon, it is more appropriate to add 20 to 30 kilograms to each batch of material.

Ferro silicon 75 for sale

Send Inquiry

Home

Phone

E-mail

Inquiry