Jan 19, 2024 Leave a message

How To Open And Block The Taphole?

How to open a tap hole?

1. Under normal circumstances, use round steel to poke it open, which is economical and can prevent fluctuations of the taphole phase electrode.


2. Boil the round steel with the help of a burn-through device. When the tap hole is difficult to open, you can use round steel to connect the burn-through device to boil it. This method not only consumes electric energy but also affects the insertion depth of the tap hole phase electrode, which is detrimental to the furnace condition.


3. Boil with oxygen. If the taphole cannot be opened using the above two methods, oxygen can be used to boil it. This method is used for new tapholes. However, safety must be paid attention to.

TSM alloy factory
No matter which method is used, the hole should be opened to the upper part of the center line of the tap hole, and the lower part of the center line is not allowed to be burned to prevent the tap hole from being burned into a pit and damaging the integrity of the tap hole.


After the taphole is opened, if the flow of molten iron is too fast, you can use a round steel with a graphite rod on the head to guide it a few times.


When tapping the iron from the new tap hole for the first time, the operation should be careful to make the flow rate of the molten iron slower. After the electrode of the iron flow trough is coked, the tap hole can be opened wider.

TSM alloy manufacturers
How to block the iron opening?


1. Before blocking, the slag around the tap hole must be burned off to make it round.


2. When blocking the taphole, choose appropriate blocking rakes and mud balls. The first mud ball should be dried, hold the mud ball to the front of the tap hole, carefully push it to the depth of the tap hole with a blocking rake, and then block the other mud balls. If after blocking several mud balls, molten iron still flows out, it must be removed and blocked again.


3. The tap hole should not be blocked, leaving a margin of 50 to 100 mm.


4. When opening or blocking the taphole, the operator should wear protective gear to prevent burns from splashing molten iron.

TSM alloy suppliers

 

Send Inquiry

Home

Phone

E-mail

Inquiry