Complete annealing process, the purpose of complete annealing of titanium and titanium alloys is to obtain a microstructure that is stable, has good plasticity or corresponds to certain comprehensive properties.
Recrystallization mainly occurs during this process, so it is also called recrystallization annealing. In addition, there are also changes in the composition, form and quantity of a phase and β phase. Most a and a+β titanium alloys are used in the fully annealed state. The two-phase zone of all A-type titanium alloys is very small, and recrystallization mainly occurs during the complete annealing process. The annealing temperature is generally selected to be 120 to 200°C below the a+β/β phase transition point. Too high a temperature will cause unnecessary oxidation and grain growth, and too low a temperature will result in incomplete recrystallization. The cooling rate has little effect on the structure and properties of this type of alloy, and air cooling is generally used.

In addition to recrystallization during annealing of near-a titanium alloys and a+β titanium alloys, there are also changes in the composition, quantity and morphology of a phase and β phase, making it more complicated to determine the annealing process. For the delivery status of metallurgical plants, the main requirements are to have a stable and plastic structure. The annealing temperature is generally selected to be 120 to 200°C below the a+β/β phase transition point, and the cooling method is also air cooling. However, for annealing before final use of the product, the impact of the annealing process on the microstructure and mechanical properties must be determined through experiments.

As for metastable β-type titanium alloys, complete annealing is also solution treatment. The annealing temperature before leaving the factory in metallurgical plants is generally selected to be 80 to 100°C above the a+β/β phase transformation point. Within the recommended full annealing process range, the specific process should be determined through testing based on the material's processing history, actual chemical composition, and the equipment used. In order to avoid unnecessary oxidation, the lowest temperature and shortest time should be used when selecting the process while meeting the performance requirements.









