Tungsten and molybdenum products are prone to oxidation and discoloration, and must be stored in an environment with a humidity below 60%, a temperature below 28°C, and isolated from other chemicals.
The oxides of tungsten and molybdenum products are soluble in water and are acidic, please note!

(1) At high temperatures (close to the melting point of the metal), it will react with other metals (iron and its alloys, nickel and its alloys, etc.), sometimes causing the material to embrittle. When heat treating tungsten and molybdenum products, you must pay attention!
Please perform heat treatment in vacuum (below 10-3Pa), reducing (H2) or inert gas (N2, Ar, etc.) atmosphere.
(2) Tungsten and molybdenum products will become embrittled when reacting with carbon, so do not contact them when heat treatment is performed at temperatures above 800°C. However, the degree of embrittlement caused by carbonization of molybdenum products is very small below 1500°C.

Machining
(1) Bending, punching, shearing, cutting, etc. of tungsten-molybdenum plate products are prone to cracks when processed at room temperature and must be heated. At the same time, due to improper processing, delamination sometimes occurs, so heating processing is recommended.
(2) However, molybdenum plates will become brittle when heated above 1000°C, causing processing difficulties, so please be careful.
(3) When mechanically grinding tungsten and molybdenum products, a grinding method suitable for various occasions must be selected.









